Two-component epoxy adhesive with a 5 minute workability

The superior quality of this fast-drying, two-component epoxy adhesive provides fast, clear and strong bonding and repairs with a strength of 130 kg/cm². The adhesive resists moisture, oils, solvents, dilute acids and alkalis. It has high heat resistance from -40°C to +100°C. The adhesive is crystal clear after curing.

RANGE OF USE:

It is suitable for bonding metals, wood, chipboard, thermosets, hard PVC, laminates, ceramics, porcelain, glass, concrete, stone, rubber, polystyrene foam, etc. Both among themselves and with each other. Not suitable for bonding PP, PE, Teflon and silicone.

Instructions for use:

The parts to be glued must be clean dry and degreased. Remove the cap of the two-shot machine, squeeze out the filler and hardener in a 1 : 1 ratio (two equal strips) and mix properly - the workability of the adhesive is 5 min. Apply the adhesive on one side, or on both sides for rough and porous materials, press the two surfaces together and fix for 20 min (using clamps or tape). Clean and seal the ends of the double-shot properly. At room temperature, the joint will reach handling strength after 20 min. The joint will reach its highest functional strength after 72 hours. The minimum working temperature is 15°C. Store in a dry and cool place.

Temperature and time dependent strength table:
Time Strength [kg/cm 2 ]
10 minutes 15
30 minutes 90
60 hours 110
72 hours 180